I was always attracted by the photos with long exposure times. It moves me this tool. The extraordinary plasticity which it owns, I find a powerful means by which to get their message to the observer, their emotions and express both drama and anguish as well as surreal tranquillity and peace.
When I resume with long exposure times using ND filters more driven ie those with the highest factor ND. In particular those used by the Lee Filters, Little stopper 6 Stop and Big stopper 10 stops.
By using this type of filter it is necessary to calculate with any precision the shutter speed and frankly I do not like to depend on tools that can deplete the battery as calculators or phones, because with long shutter speeds you already have work cut out to manage camera batteries. So I decided to create my table once I then molded plastic to protect it from the elements.
Given the small size, this table has always a place in my photographic backpacks. So I hope that it will also be helpful to you.
Link to download the table in PDF format:Table for use of ND filters
Instructions for the use of the table:
In the first of the left column, in ascending chronological order, from top to bottom, there are the times of exposure.
In the columns that are to the right of the first, we increased the exposure times for the STOP factor* relative to the ND filter that you want to use.
* (In photography, stops are unit used to quantify ratios of light or exposure, with each added stop meaning a factor of two, and each subtracted stop meaning a factor of one-half.)
To locate faster the shutter speed I used different colors for the background of the cells and different font sizes. In this manner, the columns for the use of ND filters that I use most often:
Highlighted in blue are the shutter speed times columns of “softer filters” such as ND 0.3, ND 0.6 and the ND 0.9;
Highlighted in yellow is the LITTLE stopper times column, ND 6;
Highlighted in red is the BIG stopper times column, ND 10.
The last column, the green one, is for the most extreme case, namely that the combined use of more LITTLE BIG stopper that together give an ND factor 16.
In the table I then highlighted 3 areas of cells with different colors; green, red and yellow. Each area is related to the use of a given filter; yellow for the LITTLE stopper, red for the the BIG stopper and green for the use of the LS together with the BS.
Having highlighted these areas is a visual aid to go quickly to the exposure values that use with more frequency with all filters, normally from one minute to a maximum of three. Rarely Rates of recovery use over the three minutes because the amount of hot pixels begins to be excessive and consequently then increases the time required to eliminate them in postproduction.
One important caveat; the Lee Filters alerts customers that the actual stocking rate of each LS and BS may vary + or -. I can confirm thats what’s going on and then I advise you to run tests with your filters to see as these deviate from the values in the table.
Some practical advise for outdoor use, is to print the table (no glossy paper), crop it and then laminate it. That way you can always keep it in your backpack which can still be practical in the rain, near waterfalls or resting it in winter on snow.
Example of use of the ND Filter Chart:
On a nice sunny day I want to take the waters of a waterfall. Using the technique of long exposure the water will assume a silky appearance. This effect is called motion blur and is the result of the greater amount of light reflected from the water that reaches the sensor, thanks to the long shutter speed.
First we set the equipment (a good tripod and a remote shutter control are crucial), we compose the shot and finally we set the camera to the correct exposure, lets’ assume in our example it’s 1/400 of a second; we note this value.
We install now ND filters that we chose for our photo; the higher is the ND factor that we apply, the longer is the exposure time we need to have a correct exposure. The result we’ll have is that the water of our waterfall will be brighter and silky. For our example, let’s assume to use two ND filters; the LITTLE stopper and the BIG stopper together. The sum of the value of the two ND filters is 4.8, which corresponds to 16 stop.
I pick up my ND Filter Chart and I go directly to the column relating to the ND factor of 4.8. Then I scroll down till I intersect the cells line of the exposure time of 1/400, the value that we have wrote in our note earlier. The crossover cell contains the value of 2 minutes and 40 seconds which is the exposure time that I have to use if I want to get a photo correctly exposed with those two ND filters.